Hydraulic pump is a pump, a rectangular tank , BAR, high pressure steel wire braided hose four major components, power component of the hydraulic system , its role is the original motivation of the mechanical energy into fluid pressure energy , refers to the hydraulic system pump it provides power to the entire hydraulic system . Hydraulic pump structure generally have gear pumps, vane pumps and piston pumps . Hydraulic pump connector has a straight-through, self-sealing , quick connectors three types .

    An electric hydraulic pump can be used as a variety of hydraulic equipment in the pump .

    2, the electric hydraulic pump pump and other hydraulic tools equipped , can be lifting, profiling, bending , bending row , straightening , cutting, assembly, disassembly and many work . Reduce labor intensity and improve working efficiency.

    Electric hydraulic pump to use:

    Use should play an open air nuts, oil collector block switch , plug in the power , and the quick connector set in equipped with hydraulic equipment on the fast head. Press the power switch until the motor rotation for 1-2 minutes, the switch turns off into pressurized state, then the output hydraulic oil will conduct the work , the output hydraulic oil as the load increases self- pressurized for the work until 63MPA .

    After work , turn on the switch unloading until the hydraulic oil back to the oil after removing the quick connector sets, spin a deflated nut , disconnect the electric Chennai, closed switch.

    1 , the pump using the 20th oil.

    2 , oil storage capacity must be in the oil window above the range.

    3, each fuel and oil change , we must use more than 80 mesh filter screen filters , replacement is required wash tank. Oil change period of six months. 4, the working oil temperature 10 degrees Celsius to 50 degrees Celsius.

    5, start the electric pump before the need to play an open air nut , turn switch to the unloading position .

    6, the use of the process that the motor temperature is too high , you should stop using it. Self-cooled before use.

    7 , the hydraulic pump is factory adjusted, not free profile , need to re-adjust when necessary with pressure gauge .

    8 , high pressure tubing factory into , through 105MPA tests. However, due to hose easily aging , so the user must always check , usually for six months and vortex flowmeters frequent use of three months , check 87.5MPA pressure test , if damaged , raised, leakage, you can not use .

    9, the bearings are generally six months cleaned once assembly need to add grease.